close
close

Chevy Silverado Remote Start Not Working

th 2215

Chevy Silverado Remote Start Not Working. If the engine on your silverado hd does not start when you perform the remote starting procedure, it can be due to a number of reasons: Edited november 8, 2016 by redwngr

2013 Chevrolet 1500 adding remote start module to work
2013 Chevrolet 1500 adding remote start module to work from keyninjas.net

The factory remote start is set up so that as long as the engine is throwing a code that causes a service engine soon light, it will not remote start the vehicle. Now the check engine light is on and the remote start doesn't work anymore. The hood on your silverado is not fully closed.

A Maximum Of Two Remote Starts, Or A Single Start With An Extension, Is Allowed Between Ignition Cycles.

Now the check engine light is on and the remote start doesn't work anymore. Factory fob with remote start button. It then stores a code in the ecu which can be downloaded by a professional mechanic, which should isolate the source of the failure and allow them to tell you why the car is not starting.

Edited November 8, 2016 By Redwngr

You may have to hold the remote start button for up to 5 seconds. Remote start system not working on chevy silverado hd. Videos you watch may be added to the tv's watch history and influence tv.

Maybe The Hood Sensor Position Is Incorrectly Set, Or There Is A Loose Connector On That Circuit.

The hood is not closed. You need to have the vehicle serviced and have the code cleared in order for remote start to function properly again. I have drivers side problems with my 04 chevy silverado 1500.

To Test Your Remote Start, Put The Key In The Ignition And Start The Truck.

Is there a fuse i need to replace or something? Sometimes my truck will not start at all and sometimes it does try to start but quits immediately after. One or more of the vehicle doors are open, make sure they are securely closed.

2014 Chevy Silverado 1500 Remote Start Issue.

As an fyi the remote start will not work if the check engine light is on and there is a pending or stored or current code, if you are using the factory remote start. I had a light for a bad glow plug and if i tried starting it by remote it would start and die. The hood on your silverado is not fully closed.

Leave a Reply

Your email address will not be published.